dev/disk1s2 <- the file we want is here (we think) dev/disk0s1 <- we know we are on this partition We get some output which contains something like this: We use the ls command (similar to dir in DOS). We need to know what the computer has called our drives and partitions. You now need to be EXTREMELY CAREFUL about making inadvertent or damaging changes to root. The first command will check your disk for errors and the second will give you write access to the root. You can now go ahead and enter the two commands listed on the screen. This tells us that we are currently on disk 0, partition 1 (ignore the major, minor). For legit Mac users I think you hold Apple and s key as you boot.Īfter booting, somewhere on the screen, you should see a line similar to this: ![]() For Chameleon-type hackintosh bootloaders, hit any key then type –s enter. The folder we are going to mount the drive in.įirst we need to enter Single User Mode. The type of file system that drive uses.ģ. The name of the drive we want to mount (what do we call it?)Ģ. In order to use the mount command, we first need to know three pieces of information.ġ. ![]() Now if this was DOS, it would be trivial to copy the file over – not so in OS X. I knew I had to replace a certain file on the root with a file I had stored on another drive. Recently I had a situation where I couldn’t get into the GUI (even with safe mode –x).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |